Wednesday, September 9, 2009

Open-Air Fires CANNOT Melt Steel!

I'm attempting to hammer this point until it gets through even the thickest heads:

Open air fires cannot melt steel.

Got that?

Need more proof?

Go ask a fireman.

Let me present to you a report by Robert Anderson, back in 2003:

Fire Dept Tape Invalidates Key Points of Official 911 Story
[edit]
By Robert Anderson
3rd August 2003
TOP_VIEW Internet News Inc.

Most people -- or certainly many people, especially in the U.S. -- believe the complete structural failure and total collapse of the World Trade Center towers was caused by the combustion of large quantities of jet fuel, dispersed and ignited after "hijacked" jets crashed into each tower on Sept. 11, 2001. That is the scenario promulgated to the far corners of the globe by official U.S. government sources.

Interestingly, jet fuel -- somewhat similar to common kerosene and not much different than charcoal lighter fluid -- burns at roughly 875 degrees. Whether a little or a lot of fuel is burned, it still burns at roughly the same temperature. Now: Think about all the kerosene burning in all those kerosene heaters (and lanterns), constructed primarily of thin, low-grade, steel sheet metal. Think about all those kerosene heaters burning merrily away, with temperatures perhaps approaching 875 degrees at the hottest. Think about how parts of all those kerosene heaters would then turn into bubbling pools of melted steel before the horrified eyes of countless poor souls who had no idea the fuel used in their heaters would actually "MELT" the heaters themselves.

Of course, this does NOT happen -- which gives us a pretty good idea that what had been sold far and wide by the U.S. government and innumerable media outlets as the "cause" of the trade center towers' collapse is in fact absolute fiction and fantasy, without the slightest shred of scientific fact or collaborative evidence and testimony to support such monstrous and utter nonsense. Hardened steel such as that used in the WTC beams and girders needs temperatures of approximately TWENTY-EIGHT HUNDRED (2,800) degrees to actually melt, and temperatures approaching 2,000 degrees to turn bright red and soften,

The official version of the collapse of the WTC towers is -- again -- that burning jet fuel eventually melted or liquefied the massive and seriously hard steel beams of the WTC tower(s), to the point where the beams all gave way, unilaterally and simultaneously throughout both the gigantic structures and causing their total and nearly instantaneous collapse. Well, if such doesn't happen with kerosene heaters, you can bet it doesn't happen to huge steel-beamed buildings -- and indeed it never has; especially when the fires which supposedly "caused" such total structural failure had in fact long since largely burned themselves out.

In fact, nearly a year after the monumental and treacherous catastrophe which struck lower Manhattan on Sept. 11, 2001, an audio tape of firefighter communications was finally released -- which proves that the actual conditions at and near the point of impact in the north WTC tower only moments before the building's collapse were totally inconsistent with the conditions which had to have existed for the official version to be even minimally correct.

Firefighters who had reached the eightieth floor of the north tower reported they were eyewitnesses to fact much of the fire caused by burning jet fuel had by then largely burned out, although some burning and smoldering areas still remained. Not once did firefighters on site at " ground zero" of ground zero indicate the slightest concern that fires were still burning at an intensity which threatened their own or others' safety -- certainly not that conditions were so severe that the very integrity of the entire structure itself was threatened! On the contrary: they indicated that conditions were controllable: that they planned to conduct survivors safely out of the building, and to then bring in equipment and personnel to extinguish any remaining burning/smoldering areas.

And what, exactly, does all this mean? It means that the total structural failure of the two massive, superbly-engineered/designed edifices known as the WTC towers did NOT result from jet fuel flash-fires burning at under 900 degrees Fahrenheit -- when steel used in WTC construction needed temperatures over THREE TIMES HIGHER to actually "MELT."

And THIS means that the towers were in fact toppled by use of BOMBS or similar methods.

And THIS means that a stupendously far-reaching conspiracy and cover-up -- involving the highest levels of US government -- lies behind the 9-11 "attacks on America".

by Robert Anderson


Any questions?

Read this report from Richard Gage.

In other news...was Israel responsible for the assassination of JFK? Hesham Tillawi has some ideas:

2 comments:

Greg Bacon said...

You can ask this fireman if open air flames melt steel and I'll give you a one word answer: NO.

See for yourself: Get a blowtorch and a chunk of I-beam.

Turn the torch on high and see how long it takes to soften, let alone melt that I-beam.

And that's using the gas acetylene and compressed oxygen to feed the flame, two of the most flammable gases around.

hANOVER fIST said...

Damn straight, bro!